Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 Manual gear control: Adjustment

TL4 ADJUSTMENT ADJUSTMENT OF SELECTION CABLE DURING A REMOVAL OPERATION 1 - Passenger compartment Shift the selector lever to third gear. Fit a shim (1) (6 mm between the locking ring and reverse gear interlock on the selector lever. Use a strap (2) to immobilise the lever against the shim

 Passenger's front side door wiring: Removal - Refitting

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair (see 88A, Wiring harness, Wiring: Precautions for the repair, 88A-5). REMOVAL I - REMOVAL PREPARATION OPERATION Raise the window fully. Switch off the ignition. Disconnect the battery

© 2016-2025 Copyright Renault Clio Owners Club