Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 To refit a wheel

A wheel size larger than 15” cannot be installed under the vehicle. To carry out this operation, the cable must be unwound. If the cable has been wound back up on its own, unwind it again as follows: pull the handle to unwind the cable; press the button located u

 Brake servo non-return valve: Removal - Refitting

LEFT-HAND DRIVE REMOVAL I - REMOVAL PREPARATION OPERATION K4J or K4M or K9K Remove the engine cover. II - OPERATION FOR REMOVAL OF PART CONCERNED Disconnect the non-return valve (1) at the servo. Pull and turn the non-return valve to release it from the rubber sealing washer. K9K Disconn

© 2016-2025 Copyright Renault Clio Owners Club