Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 Access to towing points

Unclip cover 4 or 6 by sliding a flat tool (or the key integrated in the RENAULT card) under the cover. Tighten towing hitch 3 fully: as much as possible by hand at first, then finish tightening it using the wheelbrace or, depending on the vehicle, the lever. Only use the towing eye 3

 Right-hand suspended engine mounting: Removal - Refitting

D4F or K9K, and JH3 REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see ) (MR 392, 80A, Battery). Remove: the scuttle panel grille (see Scuttle panel grille: Removal - Refitting) (MR 393, 56A, Exterior equipment), the scoop under the scuttle panel grille (see Scoop un

© 2016-2025 Copyright Renault Clio Owners Club