Renault Clio manuals

Renault Clio: Rear Axle Components

Renault Clio III (2005-2013) Service Manual / Chassis / Rear Axle Components

READ NEXT:

 Rubber bush: Adjustment

WARNING Never use the rear axle as support for a lifting system. ADJUSTMENT Position the vehicle on a two-post lift (see Vehicle: Towing and lifting). Release the parking brake. Remove the rear

 Rear brake pads: Removal - Refitting

16" ALUMINIUM WHEELS or 17" ALUMINIUM WHEELS or 16" STEEL WHEELS, and ELECTRONIC STABILITY PROGRAM When replacing brake pads, be sure to replace the pads on the opposite side. WARNING To avoid damag

 Rear brake hose: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING Prepare for brake fluid outflow, to p

SEE MORE:

 Diesel filter: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the front right-hand wheel (see Wheel: Removal - Refitting) (MR 392, 35A, Wheels and tyres), the right-hand wheel arch liner (see Front wheel arch liner: Removal - Refitting) (MR 393, 55A, Exterior protection). II - OPERATION FOR

 Headlight: Adjustment

DOCUMENTATION PHASE 1 ADJUSTMENT I - PREPARATION OPERATION FOR CHECK Place the vehicle in a working area equipped with a two-post lift. Note: Check that the lift is on flat, horizontal ground. Do not apply the parking brake. Check and inflate the tyres to the recommended pressure (see Tyre

© 2016-2025 Copyright Renault Clio Owners Club