Renault Clio: Engine And Cylinder Block Assembly

READ NEXT:

 Crankshaft seal on timing end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Remo

 Crankshaft seal, gearbox end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the gearbox (see Manual gearbox

 Engine oil: Draining - Refilling

D4F or K4J or K4M or K9K I - RECOMMENDATIONS FOR REPAIR Direction of fitting of the drain plug seal. K4J or K4M or K9K For an aluminium engine oil sump There is no direction of fitting for a s

SEE MORE:

 Pressure at end of compression: Check

K9K Remove the heater plugs (see 13C, Preheating, Heater plugs: Removal - Refitting, 13C-2). Disconnect: the pressure regulation solenoid valve connector (1), the flow control solenoid valve connector (2), Fit the hose end piece (Mot. 1592) in place of one of the removed plugs.

 Operating faults

The following advice will enable you to carry out quick, temporary repairs. For safety reasons you should always contact an approved Dealer as soon as possible. Using the RENAULT card POSSIBLE CAUSES WHAT TO DO The RENAULT card does not lock or unlock the doo

© 2016-2025 Copyright Renault Clio Owners Club