Renault Clio manuals

Renault Clio: Engine And Cylinder Block Assembly

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine And Cylinder Block Assembly

READ NEXT:

 Crankshaft seal on timing end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Remo

 Crankshaft seal, gearbox end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the gearbox (see Manual gearbox

 Engine oil: Draining - Refilling

D4F or K4J or K4M or K9K I - RECOMMENDATIONS FOR REPAIR Direction of fitting of the drain plug seal. K4J or K4M or K9K For an aluminium engine oil sump There is no direction of fitting for a s

SEE MORE:

 Fuses

Fuses in passenger compartment A If any electrical component does not work, check the condition of the fuses. Unclip the access flap A. To comply with current legislation, or as a precaution, you can obtain an emergency kit from your approved dealer containing a set of spar

 K9K, and JH3 or JR5 - K9K, and 772, and TL4

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). WARNING During this operation, secure the vehicle to the lift with a safety strap(s), to prevent it from becoming unbalanced. To fit the strap

© 2016-2025 Copyright Renault Clio Owners Club