Renault Clio manuals

Renault Clio: Engine And Cylinder Block Assembly

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine And Cylinder Block Assembly

READ NEXT:

 Crankshaft seal on timing end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Remo

 Crankshaft seal, gearbox end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the gearbox (see Manual gearbox

 Engine oil: Draining - Refilling

D4F or K4J or K4M or K9K I - RECOMMENDATIONS FOR REPAIR Direction of fitting of the drain plug seal. K4J or K4M or K9K For an aluminium engine oil sump There is no direction of fitting for a s

SEE MORE:

 Braking computer: Removal - Refitting

Note: Removal of the ESP or ABS computer is allowed. REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove the entire hydraulic unit (see Hydraulic brake unit: Removal - Refitting). II - OP

 Clutch pedal switch: Removal - Refitting

JH3 or JR5 or TL4, and CRUISE CONTROL - JH3 or JR5 or TL4, and VEHICLE WITH CARD REMOVAL I - REMOVAL PREPARATION OPERATION Remove: the driver side dashboard lower trim clips (1), the driver side dashboard lower trim (2). II - OPERATION FOR REMOVAL OF PART CONCERNED CRUISE CONTROL Dis

© 2016-2025 Copyright Renault Clio Owners Club