Renault Clio manuals

Renault Clio: Engine And Cylinder Block Assembly

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine And Cylinder Block Assembly

READ NEXT:

 Crankshaft seal on timing end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Remo

 Crankshaft seal, gearbox end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the gearbox (see Manual gearbox

 Engine oil: Draining - Refilling

D4F or K4J or K4M or K9K I - RECOMMENDATIONS FOR REPAIR Direction of fitting of the drain plug seal. K4J or K4M or K9K For an aluminium engine oil sump There is no direction of fitting for a s

SEE MORE:

 Exhaust gas recirculation unit: Removal - Refitting

K9K, and 750 or 752 REMOVAL Position the vehicle on a two-post lift. Remove the scuttle panel grille (see Scuttle panel grille: Removal - Refitting). Disconnect the exhaust gas recirculation solenoid valve electrical wiring harness (4). Detach the electric wiring harness. Disconnect

 Bonnet

To open the bonnet, pull the handle 1. Before performing any action in the engine compartment, the ignition must be switched off by pressing the engine stop button (please see the information on “Starting, stopping the engine” in Section 2). Unlocking the bonn

© 2016-2025 Copyright Renault Clio Owners Club