Renault Clio manuals

Renault Clio: Engine And Cylinder Block Assembly

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine And Cylinder Block Assembly

READ NEXT:

 Crankshaft seal on timing end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Remo

 Crankshaft seal, gearbox end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the gearbox (see Manual gearbox

 Engine oil: Draining - Refilling

D4F or K4J or K4M or K9K I - RECOMMENDATIONS FOR REPAIR Direction of fitting of the drain plug seal. K4J or K4M or K9K For an aluminium engine oil sump There is no direction of fitting for a s

SEE MORE:

 Renault anti-intruder device (raid)

Operating principle After the vehicle is started, the system automatically locks the doors when you are driving at approximately 6 mph (10 km/h) and over. The door can be unlocked: by pressing the door unlocking button 1. by opening a front door (vehicle stationary). NB: if a d

 Venturi: Removal - Refitting

K9K, and 750 or 752 or 766 or 768 IMPORTANT Before carrying out any work on the injection circuit, check using the Diagnostic tool that the injector rail is not under pressure, that the fuel temperature is not too high. It is essential to respect the safety and cleanliness advice whenever work

© 2016-2025 Copyright Renault Clio Owners Club