Renault Clio manuals

Renault Clio: Engine And Cylinder Block Assembly

Renault Clio III (2005-2013) Service Manual / Engine And Peripherals / Engine And Cylinder Block Assembly

READ NEXT:

 Crankshaft seal on timing end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Disconnect the battery (see Battery: Remo

 Crankshaft seal, gearbox end: Removal - Refitting

K9K REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equipment). Remove: the gearbox (see Manual gearbox

 Engine oil: Draining - Refilling

D4F or K4J or K4M or K9K I - RECOMMENDATIONS FOR REPAIR Direction of fitting of the drain plug seal. K4J or K4M or K9K For an aluminium engine oil sump There is no direction of fitting for a s

SEE MORE:

 Brake fluid

The level should be read with the engine switched off and on level ground. This should be checked frequently, and immediately if you notice even the slightest loss in braking efficiency. The engine may be hot when carrying out operations in close proximity. In addition, th

 Pump - sender: Removal - Refitting

K9K, and 772 IMPORTANT During this operation, be sure to: beware of fuel splashes when disconnecting the union, protect sensitive areas from fuel outflow. IMPORTANT Wear gloves during this operation. IMPORTANT Wear goggles with side protectors for this operation. REMOVAL I - REMOVAL PREPARATIO

© 2016-2025 Copyright Renault Clio Owners Club