Renault Clio manuals

Renault Clio: Wiring Harness

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Wiring Harness

READ NEXT:

 Headlining wiring: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Depending on the equipment level of the vehicle, remove the covers for the interior rear-view mirror in order to disconnect the rain sensor connector (see

 Front bumper wiring: Connector access

FOG LIGHTS I - LOCATION OF CONNECTORS R 33 connector (front end panel/front bumper connection). II - ACCESS TO CONNECTORS IMPORTANT Consult the safety and cleanliness advice and operation recommen

 Front left-hand wiring: Connector access

I - LOCATION OF CONNECTORS Connection R 107 (front left-hand wiring/dashboard wiring connection) composed of two to four connectors depending on equipment. R 374 connector (front left-hand wi

SEE MORE:

 Hydraulic unit - front left-hand calliper brake pipe: Removal - Refitting

LEFT-HAND DRIVE REMOVAL I - REMOVAL PREPARATION OPERATION Put the vehicle on a two-post lift (see Vehicle: Towing and lifting). Drain the coolant circuit using refrigerant charging station. Fit a pedal press on the brake pedal. Disconnect the battery (see Battery: Removal - Refitting). Remov

 Centre Lower Structure

Centre floor front side cross member: General description IMPORTANT Use a repair bench to ensure the positioning of the points and the geometry of the axle assemblies. Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for

© 2016-2025 Copyright Renault Clio Owners Club