{MAINCONT}

Renault Clio: Wiring Harness

READ NEXT:

 Headlining wiring: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Depending on the equipment level of the vehicle, remove the covers for the interior rear-view mirror in order to disconnect the rain sensor connector (see

 Front bumper wiring: Connector access

FOG LIGHTS I - LOCATION OF CONNECTORS R 33 connector (front end panel/front bumper connection). II - ACCESS TO CONNECTORS IMPORTANT Consult the safety and cleanliness advice and operation recommen

 Front left-hand wiring: Connector access

I - LOCATION OF CONNECTORS Connection R 107 (front left-hand wiring/dashboard wiring connection) composed of two to four connectors depending on equipment. R 374 connector (front left-hand wi

SEE MORE:

  Centre Lower Structure

Centre floor front side cross member: General description IMPORTANT Use a repair bench to ensure the positioning of the points and the geometry of the axle assemblies. Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for

  Side Lower Structure

Sill panel: Description B85 or K85 To replace this part, also order the expanding inserts corresponding to each of the following cases. The options for replacing this part are as follows: partial replacement of the front end section, order the exterior A-pillar insert (see 40A, General informat

{VIDEOCONT}
© 2016-2026 Copyright Renault Clio Owners Club - 0.0039