Renault Clio manuals

Renault Clio: Wiring Harness

Renault Clio III (2005-2013) Service Manual / Electrical Equipment / Wiring Harness

READ NEXT:

 Headlining wiring: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Depending on the equipment level of the vehicle, remove the covers for the interior rear-view mirror in order to disconnect the rain sensor connector (see

 Front bumper wiring: Connector access

FOG LIGHTS I - LOCATION OF CONNECTORS R 33 connector (front end panel/front bumper connection). II - ACCESS TO CONNECTORS IMPORTANT Consult the safety and cleanliness advice and operation recommen

 Front left-hand wiring: Connector access

I - LOCATION OF CONNECTORS Connection R 107 (front left-hand wiring/dashboard wiring connection) composed of two to four connectors depending on equipment. R 374 connector (front left-hand wi

SEE MORE:

 Access to towing points

Unclip cover 4 or 6 by sliding a flat tool (or the key integrated in the RENAULT card) under the cover. Tighten towing hitch 3 fully: as much as possible by hand at first, then finish tightening it using the wheelbrace or, depending on the vehicle, the lever. Only use the towing eye 3

 Solenoid valve assembly pressure sensor: Removal - Refitting

K9K, and JA5 REMOVAL REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, run command " Discharge pressure accumulator " AC081. To confirm the pressure drop, read the " Hydrauli

© 2016-2025 Copyright Renault Clio Owners Club