Renault Clio: Wiring Harness

READ NEXT:

 Headlining wiring: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Depending on the equipment level of the vehicle, remove the covers for the interior rear-view mirror in order to disconnect the rain sensor connector (see

 Front bumper wiring: Connector access

FOG LIGHTS I - LOCATION OF CONNECTORS R 33 connector (front end panel/front bumper connection). II - ACCESS TO CONNECTORS IMPORTANT Consult the safety and cleanliness advice and operation recommen

 Front left-hand wiring: Connector access

I - LOCATION OF CONNECTORS Connection R 107 (front left-hand wiring/dashboard wiring connection) composed of two to four connectors depending on equipment. R 374 connector (front left-hand wi

SEE MORE:

 Passenger compartment fan assembly control unit: Removal - Refitting

REMOVAL I - REMOVAL PREPARATION OPERATION Disconnect the battery (see Battery: Removal - Refitting) (80A, Battery). Partially remove the seal (1). Remove the side panel (2). Remove the bolt (3) from the base of the dashboard. Unclip the trim piece (4) from the driver's side dashboard

 Remote headlight beam adjustment actuator: Removal - Refitting

DOCUMENTATION PHASE 1 DISCHARGE LAMPS IMPORTANT To prevent burns, wait until the " computers - power unit " assemblies are cold before removal. IMPORTANT To prevent eye injuries: do not look at a xenon bulb when lit (voltage when lit 20000 V), do not light a bulb which has not been fitted into

© 2016-2025 Copyright Renault Clio Owners Club