Renault Clio: Mechanical Component Controls

Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls

READ NEXT:

 Manual gear control: Adjustment

TL4 ADJUSTMENT ADJUSTMENT OF SELECTION CABLE DURING A REMOVAL OPERATION 1 - Passenger compartment Shift the selector lever to third gear. Fit a shim (1) (6 mm between the locking ring and rever

 Master cylinder: Removal - Refitting

F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE WARNING Prepare for brake fluid outflow, to prevent damage to the mechanical parts and bodywork around the braking system. REMOVAL I - REMOVAL PRE

 Master cylinder - front right-hand calliper brake pipe: Removal - Refitting

LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equi

SEE MORE:

 Roof sun blind

Fixed sunroof blind Opening: push handle 1 upwards, then guide it until it opens fully; Closing: pull the handle 1 until it clicks into the catch. If the blind becomes skewed when opening or closing, close fully and then fully open the blind. Front sun visor Lower sun visor

 Immobiliser system: List and location of components

I - LIST OF COMPONENTS II - LOCATION OF COMPONENTS VEHICLE WITH KEY 1 - Antenna/Transponder ring 2 - Ignition switch 3 - UCH 4 - Key VEHICLE WITH CARD 5 - Front starting aerial 6 - Central starting aerial 7 - Rear starting aerial 8 - Start button 9 - Card reader 10 - UCH 11 - Electric ste

© 2016-2025 Copyright Renault Clio Owners Club