Renault Clio: Mechanical Component Controls
Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls
- Manual gear control: Adjustment
- Master cylinder: Removal - Refitting
- Master cylinder - front right-hand calliper brake pipe: Removal - Refitting
- Master cylinder - front left-hand calliper brake pipe: Removal - Refitting
- Master cylinder - underbody union brake pipe: Removal - Refitting
- Brake servo non-return valve: Removal - Refitting
- Brake servo: Removal - Refitting
- Vacuum pump: Removal - Refitting
- Accelerator pedal: Removal - Refitting
- Brake pedal: Removal - Refitting
- Brake pedal switch: Removal - Refitting
- Brake compensator: Removal - Refitting
- Brake compensator: Check
- Parking brake lever: Removal - Refitting
- Clutch control: List and location of components
- Clutch pedal switch: Removal - Refitting
- Clutch circuit: Bleed
- Clutch master cylinder: Removal - Refitting
- Clutch circuit: Removal - Refitting
- Gear control: List and location of components
- Parking brake cables: Removal - Refitting
- Brake servo: Check
READ NEXT:
Manual gear control: Adjustment
TL4
ADJUSTMENT
ADJUSTMENT OF SELECTION CABLE DURING A
REMOVAL OPERATION
1 - Passenger compartment
Shift the selector lever to third gear.
Fit a shim (1) (6 mm between the locking ring and
rever
Master cylinder: Removal - Refitting
F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE
WARNING
Prepare for brake fluid outflow, to prevent damage
to the mechanical parts and bodywork around the
braking system.
REMOVAL
I - REMOVAL PRE
Master cylinder - front right-hand calliper brake pipe: Removal - Refitting
LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM
REMOVAL
I - REMOVAL PREPARATION OPERATION
Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (MR 392, 02A, Lifting equi
SEE MORE:
Injector leak flow: Check
K9K, and 750 or 752 or 764 or 766 or 768
Note:
Vehicles equipped with the K9K*768 engine may or
may not be equipped with an intercooler.
Disconnect the battery (see Battery: Removal - Refitting)
(MR 392, 80A, Battery).
Disconnect the inlet pressure sensor (1).
Remove the air duct (3) betwee
Diesel injector: Configurations
K9K, and 750 or 752 or 766 or 768
To configure the injectors, (see MR 394 Fault finding,
Diesel Injection, Configuration and programming).
Diesel injector: Removal - Refitting
K9K, and 764 or 772
IMPORTANT
To avoid all risk of damage to the systems, apply
the safety and cleanliness instructions
© 2016-2026 Copyright Renault Clio Owners Club - 0.0053
