Renault Clio manuals

Renault Clio: Mechanical Component Controls

Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls

READ NEXT:

 Manual gear control: Adjustment

TL4 ADJUSTMENT ADJUSTMENT OF SELECTION CABLE DURING A REMOVAL OPERATION 1 - Passenger compartment Shift the selector lever to third gear. Fit a shim (1) (6 mm between the locking ring and rever

 Master cylinder: Removal - Refitting

F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE WARNING Prepare for brake fluid outflow, to prevent damage to the mechanical parts and bodywork around the braking system. REMOVAL I - REMOVAL PRE

 Master cylinder - front right-hand calliper brake pipe: Removal - Refitting

LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equi

SEE MORE:

 Rigid brake pipe: Repair

This procedure applies to copper pipes diameter 4.7 mm. Note: This procedure does not apply to: hybrid pipes (pipe + hose), pipes with diameters 6 mm and 8 mm. REPAIR I - PIPE PREPARATION OPERATION WARNING To avoid causing a breakdown in hydraulic brake circuit, do not squash or bend the rigid

 F4R

REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (02A, Lifting equipment). Disconnect the battery (see Battery: Removal - Refitting) (80A, Battery). Perform the following operations: drain the engine oil (see 10A, Engine and

© 2016-2025 Copyright Renault Clio Owners Club