Renault Clio: Mechanical Component Controls

Renault Clio III (2005-2013) Service Manual / Chassis / Mechanical Component Controls

READ NEXT:

 Manual gear control: Adjustment

TL4 ADJUSTMENT ADJUSTMENT OF SELECTION CABLE DURING A REMOVAL OPERATION 1 - Passenger compartment Shift the selector lever to third gear. Fit a shim (1) (6 mm between the locking ring and rever

 Master cylinder: Removal - Refitting

F4R or K4J or K4M or K9K or M4R, and LEFT-HAND DRIVE WARNING Prepare for brake fluid outflow, to prevent damage to the mechanical parts and bodywork around the braking system. REMOVAL I - REMOVAL PRE

 Master cylinder - front right-hand calliper brake pipe: Removal - Refitting

LEFT-HAND DRIVE, and WITHOUT ANTI-LOCK BRAKING SYSTEM REMOVAL I - REMOVAL PREPARATION OPERATION Position the vehicle on a two-post lift (see Vehicle: Towing and lifting) (MR 392, 02A, Lifting equi

SEE MORE:

 Steering wheel/Power-assisted steering

Adjusting the steering wheel height and depth Pull lever 1 and place the steering wheel in the required position; push the lever beyond the point of resistance to lock the steering wheel in place. Make sure that the steering wheel is correctly locked. For safety reasons, only

 Display A

To access display 1 for setting the time, press button 2 or 3. Wait for a few seconds. The hours and minutes flash and you are now in setting mode; press and hold button 2 or 3 to set the hours. Once the minutes flash, repeatedly press or press and hold button 2 ou 3 to set the time.

© 2016-2025 Copyright Renault Clio Owners Club