Renault Clio: Sequential Gearbox

READ NEXT:

 Sequential gearbox: Precautions for the repair

D4F or K9K, and JA3 or JA5 I - SEQUENTIAL GEARBOX WARNING If any operation is carried out on the electro-hydraulic unit, it is essential to clean the unit using a cleaning product and compressed air.

 Pump assembly reservoir: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION IMPORTANT Before any operation on the sequential system, discharge the accumulator using the Diagnostic tool. To discharge the accumulator, ru

 Electro-hydraulic unit: Removal - Refitting

K9K, and JA5 REMOVAL I - REMOVAL PREPARATION OPERATION Note: When replacing the electric pump assembly, always replace the control relay. IMPORTANT Before any operation on the sequential system, disc

SEE MORE:

 Valves: Adjustment

D4F I - VALVE CLEARANCE ADJUSTMENT PREPARATION OPERATION Fit the vehicle on a two-post lift (see Vehicle: Towing and lifting). Remove: the front right-hand wheel (see Wheel: Removal - Refitting), the front right-hand wheel arch liner (see MR 393 Bodywork, 55A, Exterior protection, Front

 Scuttle side panel: General description

Note: The information contained in the following describes the general repair procedure for all vehicles having the same design for this part. Before reading the following general information, make sure that there are no special notes associated with the vehicle. These special notes are specified i

© 2016-2026 Copyright Renault Clio Owners Club